Instructions / Assembly

Fig 3

Fig 1 Fig 2

Fig 4 Fig 5

MANUAL INPUT

Please follow the steps below to manually add your alarm host to the HomeBot app.

1. Insert the female end of the AC adapter into the DC IN port (Fig 1) located at the bottom of the host and

connect the other end into a wall outlet. Then connect one end of the Ethernet cable into the Ethernet port (Fig

1) (also located at the bottom of the alarm host) and the other end into your wireless router. Make sure you use the

cable management grooves (Fig 2) to help keep the cables organized.

NOTE: The Ethernet cable is only required for setup and can be removed once you connect the host to your Wi-Fi

network.

2. Make sure your Smartphone or tablet is connected to the same Wi-Fi network that the alarm host is connected

to and tap on the Manual Input option (Fig 3). Turn your alarm host upside down and manually input the 24

digit (alpha/numeric) Serial ID (Fig 4) as the DID (Fig 4).