ASSEMBLY INSTRUCTIONS T-4096XXB AND T-4096XXT T-4096XXB AND T-3896XXT Description Item No. : MILANO TABLE BASE : T-4096XXB AND T-4096XXT OR T-3896XXT (PACKED IN SEPARATE BOX) ITEM NO.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is missing or defective, please contact the store where purchased. If hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
PART LIST T-4096XXT When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: NO Description Qty A Top 1 Sketch PART LIST T-3896XXT When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: NO Description Qty A Top 1 ITEM NO.
PART LIST T-4096XXB When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the following parts: NO Description Qty B Long leg D Pedestal column Sketch NO Description Qty 2 C Short leg 2 2 E Crossbar 1 Sketch HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging.
STEP 1 Attach crossbar (E) to pedestal columns (D) with bolts (6) and u-washers (8) as shown below. Tighten with Allen key (7). Insert short legs (C) into long legs (B) and attach with screws (5) as shown below. Tighten with a screwdriver. Attach legs (B) to pedestal columns (D) with nuts (1), and washers (2) and (3) as shown below. Tighten with the wrench (4). STEP 2 Use Allen key (7) to loosen bolts and washers and take out the mounting plates underneath the table top as shown below. A ITEM NO.
STEP 3 Attach mounting plates on top of the pedestals (D) with nuts (1), and washers (2) and (3) as shown below. Tighten with the wrench (4). STEP 4 Carefully place the base on the bottom side of the top (A). Attach mounting plates to top (A) with bolts and washers (from step 2) as shown below. Tighten with Allen key (7). A ITEM NO.
STEP 5 Unlock the table top from both sides underneath the top as shown below. Pull the two parts of the table top apart. ITEM NO.
STEP 6 Place the leaves in the center of the open table top, as shown below. Note: The metal swivel bar bracket is very flexible and a slight twist of one half of the leaf can get the leaf into alignment. With one of these tops opened and in the topside up position and can be attached to the base to accomplish this too.
STEP 7 Push the table top closed. Lock the mechanism underneath two sides of the table top as shown below. 1 LEAF ITEM NO.
