User's Manual

13 By Firstech, LLC By Firstech, LLC 12
Notes for Wire Connection
c@C@S
Remote LED Functions and Descriptions
Pin #1 : Light Blue This needs to be connected to the parking brake. This wire requires a (-) input to activate. This wire serves two functions:
1. To engage Reservation Mode for manual transmissions, reference the users or install guide.
2. To activate the Turbo Timer, reference the users or install guide.
Pin #2 : Gray/ Black This is the (-) shutdown for the Hood Trigger. This wire serves two functions:
1. It prevents the remote start from activating while the hood is open
2. It will trigger a full alarm if the hood is opened when the alarm has been armed.
Pin #3 : Light Blue/ White This is the (+) shutdown for the foot brake. This wire will shut down the remote start if the foot brake is pressed.
Pin #4 : Violet/ Black This wire is the (-) trigger input, which may be connected to a trunk pin or trunk trigger as a buyer option.
Pin #5 : Red/White
This wire is the (-) trigger input for the door trigger. You would connect this to the trigger that shows (-) when the door is opened.
Pin #6 : Red This wire is the (+) input for the door trigger. You would connect this to the trigger that shows (+) when the door is opened.
Pin #7 : Brown /Black This is the trigger input for a (-) glow plug wire.
Pin #8 : Brown /White This is the trigger input for a (+) glow plug wire.
Pin #9 : Yellow/ Black This wire serves as the Tachometer input or the Alternator input. Either way you use it, it is for engine sensing. This wire tells the
CompuStar when to quit cranking the starter of the vehicle. There are a couple of ways to find the correct voltage for either type of sensing. Please review the
following tips on the next page.
ᵉᵉ
Tachometer Sensing
1. You will need an Auto Ranging Digital Meter to test for the correct tach.
2. Most tach wires are located at the (-) side of the ignition coil. In some cases you may have to go to the ECU or Coil pack.
3. The Voltage will read (AC), so you will need to set you meter accordingly.
4. With the vehicle off the voltage should read 0.00 AC.
5. Start the vehicle and at this time the voltage should fluctuate between 1 and 8 volts AC.
6. Connect the tachometer wire to the yellow/black.
7. Make sure that the Dipswitch #1 is set to the On position.
8. While the vehicle is running press the small black button on the side of the brain, Parking Light will flash once if you have the correct Tach wire.
9. If the cars parking lights flash 3 times, there is a problem with the tachometer learning. Wait for 2 seconds and the cause for the error will be indicated by the
number of times the parking lights flash.
10. Diagnosing Tach Learning Error
If the cars parking lights flash 3 times, there is a problem with the tachometer learning. Wait for 2 seconds and the cause for the error
will be indicated by the number of times the parking lights flash.