Operation Manual

NOTES 0 You can sustain battery level display by holding down the Power switch.

When the battery capacity drops below the limit, the “b.c” display blinks

and then goes out.

When the battery level is indicated by only two or three dots, replace the

battery.

5.3 Auto Power-off

To save battery capacity, the L-408 is automatically turned off (and all readings are

erased) 10 minutes after your last operation.

NOTE

When the L-408 is automatically turned off by Auto Power-off,

settings (such as mode selection, exposure setup and measured

values) are saved. They are displayed again when the POWER switch

is turned on.

---

5.4 IS0 film speed setup

Hold down the IS0 button

(@iJ)

and press the UP or

DOWN

button

(c=@) to set the IS0 film speed. The UP

button is used to select higher film speed, and the DOWN

button for more than one second continuously increases

or decreases the film speed.

NOTE /

---

e You can also change the IS0 film speed after taking measurement.

The new calculated value is displayed when the film speed is changed after taking the

measurement.

5.5 Light-receiving method setup

Select incident light metering (with lumisphere in the UP or DOWN position) or

reflected tight metering (with 5-degree spot meter).

Eyepiece

cover

Closed

Open

Eyepiece

cover

Incident light metering

(with cover closed)

Reflected light metering

(with cover open)