Operation Manual
Aperture priority
i
El
@iJ
“3:’
measurement is set at “F:5.6+3/10”
and “T:
1/30".
is
r-
Ii
D
-1
rr
-1
r-1
3
1
_
3
!J
-
.a
z
NOTES
*
Bars and analog values are displayed.
@
Ambient light metering continues as long
as you keep pressing the measuring
switch.
0 When you change the film speed, the
measurement is recalculated and a new
value is displayed.
@
When the measuring range is exceeded,
[
“Eu” (underexposure) or “Eo”
(overexposure) appears. If "Eu"
;a
r::
G
/3r
appears, slow down the shutter speed or
i
b.cL
’
-
IL
3
1~1.1.1.1.1.1.1.,~,.,~,...,
t
open the aperture.
1 1.4 2 2.8 4 5.6 8 11 16 22 32 45 64 90 0
If “Eo” appears, increase the shutter speed or close the aperture.
6.5 Data memory
In the ambient light mode, you can store up to three aperture values at shutter speed
priority measurements in memory.
After measurement, press the memory button (@c=).
The aperture value will be displayed on the analog scale
with (
l or
1).
You can store up to three measurements. The fourth
measurement is displayed but not stored.
You can store three measurements for each light-
receiving method. (See page 13 (5). So, a total of 9
measurements can be stored in memory.
When measuring and storing data with the lumisphere in the DOWN position, your
L-408 does not display the values measured with the lumisphere in the UP
position or in the reflected light metering mode, To recall these measurements,
switch the mode to lumisphere UP position or reflected light metering.
To clear the memory, press the Clear Memory button.
f
I
I
m
*
The Clear Memory button clears all 9 measurements from the memory .
12