Operation Manual

NOTES
l If the camera’s flash does not fire, use flash measurement without cord.
l When the IS0 setup is changed, the measurement data is recalculated
and redisplayed .
l If the shutter speed is changed after measurement, the measurement is
lost and the aperture is cleared to zero (0).
l When the measuring range is exceeded, “Eu” (underexposure) or “Eo”
(overexposure) appears. Correct the shutter speed or the light source.
* Synchro cord (optional):
A 5-meter-long synchro cord with three
plugs is available for synchronous metering
between your L-408 and the flash unit or
between the camera and the flash unit. It is
very convenient as no cord replacement is
required during shooting pictures. The L-
408 is also equipped with a connector
terminal lock for securing cable connection.
light
7.2 Data memory
In the single flash measurement mode, up to three measurements can be stored in
memory. Memory storage is same as for the ambient light measurement (see 6.5 of
Page 12).
7.3 Cumulative flash measurement
@ Flash measurement with cord
Select the (Flash measurement with cord) mode
using the mode selection button
(~=a).
@J Cumulative flash measurement
Select the cumulative flash measurement mode using
the F/EV/MULTI button
(G@).
@ Shutter speed setup
Set the desired shutter speed using the UP/DOWN
button
(=@).