Operation Manual

NOTES e When the measuring range is exceeded, “Eu” (underexposure) or “Eo”

(overexposure) appears. Correct the shutter speed or the light source.

If a rapid start luminescent lamp or special illumination lamp is to be

measured (although no flash fires), connect the synchro cord and use

the flash measurement with cord.

8.2 Data memory

In the single flash measurement mode, up to three measurements can be stored in

memory. Memory storage is the same as for ambient light measurement (see 6.5 of

Page 12).

8.3 Cumulative measurement

(i’

Flash measurement without cord

Select the (Flash measurement without cord)

mode using the mode selection button

(+a).

@ Cumulative measurement

Select the flash cumulative measurement mode

using the F/EV/MULTI button

(&)).

@ Shutter speed setup

Set the desired shutter speed using the UP/DOWN

button

(&)).

+ In this mode, you can set the shutter

speed from 1 sec to 1/500 sec. After 1/

NOTE

)

500 sec 1/75, 1/80, 1/90, 1/100, 1/200

and 1/400 sec. appear in the display and

you can select a particular shutter speed.

@ Measurement

imom

I’;2

Press the measuring switch. The

mark

\’

continues blinking and your L-408 enters the

174

ICJ

standby mode.

1 1.4 2 2.8 4

11162232C64