Operation Manual

When the flash fires, the aperture value will appear on the LCD panel. The
cumulative exposure of each measurement and the number of flashes also
appear.
When a single flash firing is
measured
b‘ 0 rj
ii ,-,- ’
j
iJ/J$‘-
d c 3
/,
,.e..r,.l*.*l.
1 1.4 2 2.8 4 5.6 8 11 162?324564d
When four flash firings are measured
(
*.,.,*,.,..*..,.,*
1 1.4 2 2.8 4 5.6 8 11 16 22 32 45 64 90
~3 To cancel Cumulative mode, just press the FEV/MULTI button. To restart
metering with new setup, press the F/EV/MULTI button.
NOTES
@ After this measurement, the
remains in standby mode.
mark continues to blink and your L-408
0 The standby mode continues for approximately 90 seconds.
8 If the flash is NOT metered by your L-408 (when the flash is dimmer
than the ambient light), use flash measurement with cord.
* If the shutter speed is changed after measurement, the measurement is
lost and the exposure is cleared to zero (0).
l If a rapid start luminescent lamp or special illumination lamp light is to
be measured (although no flash fires), use flash measurement with
cord.
* No flash bulb measurement is supported. Use the synchro cord
instead.
8.4 Contrast measurement
Contrast measurement is the same as for ambient light measurement (see Step 6.6 of
Page 13).
19