User manual

26
Redial
1. Press REDIAL (Left) soft key.
2. The LCD shows the last phone number dialed. To dial this number, press
DIAL (Left) soft key.
3. Use Up or Down Arrow Key to scroll through the last 10 phone numbers
dialed. Select and press DIAL soft key.
Note: Intercom numbers (Handset ID) are not stored in the last 10 numbers
dialed log.
Receiving a Telephone Call
1. When an incoming call arrives, the ringer will ring or vibrate unless the ringer
has been turned off.
2. If the handset is on the charger cradle (ringer will be temporarily switched to
“Ring” if it has been set to “Vibrate”), lift the handset and start conversation.
3. If the handset is not on the cradle, press any key (except PWR, END, and
the Silent soft key) to answer.
Notes:
a. The LCD displays the line number of the call.
b. Press the SILENT (Left) soft key to ignore the call. Unlike turning off
the ringer (from the handset menu), the SILENT key operation is valid
only for the current call.
c. If Caller ID service is available, the LCD will display the incoming call
information. If the LCD shows “Private” or “Unknown”, the caller’s
information may have been blocked by the caller or the originating
phone company.
Receiving an Intercom Call
1. When an intercom call arrives, the ringer will ring or vibrate unless the ringer
has been turned off.
2. If the handset is on the charger cradle (ringer will be temporarily switched to
“Ring” if it has been set to “Vibrate”), lift the handset and start conversation.
3. If the handset is not on the cradle, press any key (except PWR, END, and
the SILENT soft key) to answer.
Notes:
a. The LCD displays the caller’s Handset ID.
b. Press the SILENT (Left) soft key to ignore the call. Unlike turning off
the ringer (from the handset menu), the SILENT key operation is valid
only for the current call.
27
Ending a Call
To end a telephone or intercom call, press END key or place handset into
charger cradle.
Adjusting Receiver (Earpiece) Voice Volume
1. Voice volume can only be adjusted during a call.
2. There are 6 levels of volume selections. Default = 4.
3. Use Up and Down Arrow key to turn up or down the earpiece volume.
4. The new setting remains effective for all future calls until changed.
Note: To achieve maximum volume, adjust the position of the earpiece to align
with the ear.
Placing a Call on Hold
1. When a call is in progress, it can be put on hold by pressing the Hold (Right)
soft key.
2. To return to the conversation, press “Unhold” (Left) soft key.
Notes:
a. The call being placed on hold can only be “un-hold” by the handset
that puts it on hold.
b. Handset LCD displays a call is being on hold. An alert tone (4 long
beeps) every 30 seconds will remind the handset that a call is being on
hold.
c. If the operation (e.g., call transfer) after putting a call on-hold fails, the
held call may be dropped.
d. You can power off the handset (e.g., change battery) while call is on
hold. After power on again, you can continue the call by pressing
UNHOLD (Left) soft key or select “3” from the Option menu to
terminate the hold state.
Mute
1. After a link is established, you can press Mute (Left) soft key to mute the
handset microphone.
2. When mute is active, the other end will not hear your voice, but still can
speak to you.