User's Manual
Table Of Contents
- User Manual of SRM100A(Rev1.0)
- 1. Introduction
- 2. Hardware Architecture:
- 2.1 Main Chipset Information
- 2.2 Circuit Block Diagram
- Figure 1-1 SRM100A block diagram and System Interface
- 3. Operational Description
- 3.1 Features
- 3.2 Time base of the RF frequency
- 3.3 Transmission
- 3.4 Receiver
- 3.5 Product Details
- 3.6 Output Power tolerance
- 3.7 SRM100A Category of signal
<FCC/IC Warning>
FCC Part 15.19 Statements:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
FCC Part 15.21 statement
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
<Regulatory notice to host manufacturer according to KDB 996369 D03 OEM Manual v01>
List of applicable FCC rules
This module has been granted modular approval as below listed FCC rule
parts.
-FCC Rule parts 15C(15.247)
Summarize the specific
operational use conditions
-The OEM integrator should use equivalent antennas which is the same type
and equal or less gain then an antenna listed in this instruction manual.
RF exposure considerations
The module has been certified for integration into products only by OEM
integrators under the following condition:
-The antenna(s) must be installed such that a minimum separation distance
of at least 20 cm is maintained between the radiator (antenna) and all
persons at all times.
-The transmitter module must not be co-located or operating in conjunction
with any other antenna or transmitter except in accordance with FCC multi-
transmitter product procedures.
-Mobile use
As long as the three conditions above are met, further transmitter testing will
not be required. OEM integrators should provide the minimum separation
distance to end users in their end-product manuals.
l'exposition aux RF
L’antenne (ou les antennes) doit être installée de façon à maintenir à tout
instant une distance minimum de au moins 20 cm entre la source de
radiation (l’antenne) et toute personne physique.
Caution: Any changes or modifications to this device not explicitly approved
by manufacturer could void your authority to operate this equipment.
Attention:
Les changements ou modifications de cet appareil non expressément
approuvé par le fabricant peuvent annuler votre droit à utiliser cet
équipement.
Antennas list
This radio transmitter [25119-SRM100A] has been approved by Innovation,
Science and Economic Development Canada to operate with the antenna
types listed below, with the maximum permissible gain indicated. Antenna
types not included in this list that have a gain greater than the maximum gain
indicated for any type listed are strictly prohibited for use with this device.
*FCC/IC requirements for antenna list
This module is certified with the following antenna.
-Type: External Antenna(Dipole antenna)
-Max. peak Antenna gain
Version 1.0 SEONG JI page 5 of 6