User's Manual

Frequency band
Sigfox(INNO-ADI-0269)
BT(INNO-EWFSWS-151)
BLE(2.4GHz)
5.33dBi
Sigfox(900MHz)
1.98dBi
Any new antenna type, higher gain than listed antenna should be met the
requirements of FCC rule 15.203 and 2.1043 as permissive change
procedure. The use of a different trace layout other than approved requires a
Class II Permissive Change or a New Grant as appropriate.
End Product Labeling
The module is labeled with its own FCC ID. If the FCC ID is not visible when
the module is installed inside another device, then the outside of the device
into which the module is installed must also display a label referring to the
enclosed module. In that case, the final end product must be labeled in a
visible area with the following:
-Contains FCC ID: 2AS8LSRM100A
-Contains IC: 25119-SRM100A
Le module SRM100A est étiqueté avec sa propre identification FCC et son
propre numéro de certification IC. Si l’identification FCC et le numéro de
certification IC ne sont pas visibles lorsque le module est installé à l’intérieur
d’un autre dispositif, la partie externe du dispositif dans lequel le module est
installé devra également présenter une étiquette faisant référence au
module inclus. Dans ce cas, le produit final devra être étiqueté sur une zone
visible avec les informations suivantes :
« Contient module émetteur identification FCC ID : 2AS8LSRM100A
« Contient module émetteur IC : 25119-SRM100A
Information on test modes and
additional testing requirements
OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, additional
transmitter in the host, etc.).
Additional testing, Part 15
Subpart B disclaimer
The final host product also requires Part 15 subpart B compliance testing
with the modular transmitter installed to be properly authorized for operation
as a Part 15 digital device.
Version 1.0 SEONG JI page 6 of 6