User's Manual

Appendix E

Command Line Interface

Overview

If desired, the Command Line Interface (CLI) can be used for configuration. This creates the

possibility of creating scripts to perform common configuration changes. The CLI requires a

Telnet connection to the Wireless Access Point.

Using the CLI - Telnet

1. Start your Telnet client, and establish a connection to the Access Point.

e.g.

Telnet 192.168.0.228

2. You will be prompted for the user name and password. Enter the same login name and

password as used for the HTTP (Web) interface.

The default values are admin for the User Name, and password for the Password.

3. Once connected, you can use any of the commands listed in the following Command

Reference.

Command Reference

The following commands are available.

config vap Config Virtual AP X

? Display CLI Command List

help Display CLI Command List

get 11nampdu Set 11n A-MPDU Aggregation Mode

get 11namsdu Set 11n A-MSDU Aggregation Mode

get 11nguardinterval Set 11n Guard Interval Mode

get 11nsubchannel Set 11n Extension Sub-Channel

get 11nradioband Set 11n Radio Band

get 802.11d Display 802.11d Mode

get acctserver Display Accounting Server

get acctport Display Accounting Port

get acctsecret Display Accounting Secret

get acl Display Access Control Status

get active Display VAP Active (up) Mode

get aging Display Idle Timeout Interval

get authentication Display Authentication Type of WEP