by SLSUPB105 SLSUPB125 SLSUPB135 SLSUPB145 Thunder Wave SUP Stand Up Water Paddle-Board SLSUPB105 - SLSUPB125 - SLSUPB135 - SLSUPB145
INTRODUCTION IMPORTANT! PLEASE READ THIS MANUAL CAREFULLY, AND IN ITS ENTIRETY, BEFORE INFLATING, ASSEMBLING OR USING YOUR THUNDER WAVE SUP. Please read this manual carefully before using this product. Familiarize yourself with the features of the SUP and ask for professional training if you are inexperienced in handling this type of board. For your full enjoyment it is important to follow proper safety procedures and rules of the waterway that apply to all SUPs.
WHAT’S WHAT? Carrying Handle Tie down Bungee Cords Air Valve SLSUPST15 Sup Seat *sold separately Leash Plug Fins 3 www.PyleUSA.
GETTING STARTED CONTENTS • Board x 1 • Bag x 1 • Repair kit x 1 • Hand pump x 1 • Leash x 1 • 3 piece SUP paddle x 1 INFLATING THE SUP BOARD 1. Roll out the SUP board until it is laying flat with top side facing up. 2. Push the air valve down while at the same time twisting slightly. This will put the air valve in the up position (Note: when the air valve is UP, air can only flow into the SUP board. When it is in the DOWN position, air can flow in and out of the SUP board). 3.
GETTING STARTED SUP BOARD MR PUMP Your SUP Board comes with a high pressure pump. This pressure pump, pumps low volume of air with each pumping motion. It takes longer to fill the board with air, but allows the board to reach a higher air pressure. This is good for achieving maximum performance from the board. The SUP board air pump is also lubricated with oil. To ensure the life of the air pump, make sure the pump is fully lubri-cated before and during each use.
GETTING STARTED REPAIR KIT If your board needs repair, use the patches in the repair kit and follow these steps: 1. Deflate the board completely, lay it flat and wait for it to dry. 2. Cut a patch that is 2 inches larger than the tear/rip all the way around. 3. Use alcohol to clean the repair area. 4. Apply three coats of adhesive to the patch and the board. Wait 5 minutes in between each coat. 5. Place the patch over the tear/rip.
APPENDIX FOR YOUR SAFETY • Check your board and equipment before going in the water. • Try to avoid going on the water alone. • Always have a mode of communicating while on the water. • Check weather conditions and tide before going out to ride. • Avoid paddling when winds are blowing away from shore. • Be aware of tide and water flow and how it will affect your traveling time. • Wear wetsuits or drysuits. • Always wear a life jacket or some sort of floatation device. • Always wear your board leash.
by