Operation Manual

Pictures, Lines, and Shapes 171
Any filter can be temporarily disabled, reset, or deleted from the trial zone.
To disable:
Click , then click to enable again.
To reset:
Click
. Any changes to settings are reverted back to
the filter's defaults.
To delete:
Click .
Once you're sure that you want to keep you filter, you'll need to commit the
filter to your filters stack.
To commit your filter:
• Click Commit to accept your changes. This adds the
filter to the right-most Filters stack where additional filters can be
added and built up by using the same method.
Adjustments are applied such that the most recently added
filter always appears at the bottom of the list and is applied to
the picture last (after the other filters above it).
To reorder filters:
• Drag and drop your filter into any position in the stack. A dotted line
indicates the new position in which the entry will be placed on mouse
release.
To add a filter directly (without trialling):
• Click Add Quick Filter at the top of the Filters stack and choose
a filter from the flyout categories. The filter is applied directly to the
stack without trialling.