How to Guide

8
To install the legs, thread the washer over the screw on the leg.
Next, screw the leg into the nutsert on the frame. Do not over
tighten.
STEP 1
STEP 2
installation guide
Always use two people when setting up the base, moving or ipping the base.
Place the bed base box in a desired location with the bottom of
the box facing up.
Remove the binding straps and packing materials, making sure
not to puncture the box with any sharp objects.
Remove the bed base from the box keeping the bottom of
the base facing upwards.
STEP 3
STEP 5
STEP 6
Uncoil input cord (connected to control box’s
power port) and plug into Power Supply.
To install headboard brackets (sold separately)
see instructions on page 14 and 15
Uncoil the Power Cord and connect to the
Power Supply. Place Power Supply on the
ground and extend from the base. Ensure
that the Power Supply and all attached
cords are directed toward the desired
surge protector.
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
The 3-in-1 legs untwist into separate sections for custom leg
height options (3", 6", or 9")
STEP 4
To sync two bases with the sync cord - see page 13
Locate the battery backup strap
Store the battery backup strap in a convenient
location for emergency use.
For operating instructions, see owner's
manual.