iComfort Auto Gliding BASSINET 701605-XXXX Styles and colors may vary ASSEMBLY INSTRUCTIONS WARNING: CHOKING HAZARD Adult assembly required because of small parts. Keep assembly parts out of reach of children under 3 years. REQUIRED: Phillips Screwdriver (not included) IMPORTANT: Read all instructions before assembly and use of the product. Keep the instructions for future reference. www.DeltaChildren.
Consumer Information WARNING WARNING: Do not use this bassinet if you cannot exactly follow the accompanying instructions. Failure to follow these warnings and instructions could result in serious injury or death. • Read all instructions before assembling unit. KEEP INSTRUCTIONS FOR FUTURE USE. DO NOT USE THIS UNIT IF THE INSTRUCTIONS CANNOT BE STRICTLY FOLLOWED. • Before each usage or assembly, inspect unit for damaged hardware, loose joints, missing parts or sharp edges.
STOP Please DO NOT return this product to the store. If you experience any difficulty with assembly, missing parts or use, please DO NOT return this item to the store. Retail stores are unable to properly assist you. Contact our Customer Service Department directly for assistance (646) 435-8726 www.DeltaChildren.com • gcs@deltachildren.com ©2019 Delta Children’s Products, Inc.
Parts IMPORTANT! Please remove all parts from the package and identify them before assembly. Frame Front Base Leg with Wire Connection (X1) (For power housing and power cord attachment) Back Base Leg (X1) P TO NT O FR OM TT BO Auto-Glide Housing (X1) (Needs 2 - M6 - 3.5cm - screws to attach to front base leg with wire connection) T N RO F Mattress Support Board Support Tubes (X2) Fabric Liner Mattress Pad Fabric Storage Liner Customer Service Tel. (646) 435-8726 Sheet 4 www.DeltaChildren.
Parts IMPORTANT! Please remove all parts from the package and identify them before assembly. Phillips Screwdriver (NOT INCLUDED) Locking Casters (X4) Mobile With Plush Stars Power Cord Hardware *Screws are shown in actual size - 10 total screws M6 - 1.7cm x 8pcs M6 - 3.5cm x 2pcs (Used for power housing assembly) Mobile Arm Customer Service Tel. (646) 435-8726 5 www.DeltaChildren.
Top Frame Assembly NOTE: Make sure front of frame is aligned with top front mattress support 1 • Place the frame on a flat surface and extend the support legs out. 1 NOTE: You may need the help of another adult for assembly. • Locate the mattress support board and align the front of frame to top of support board front. 2 Support Legs • Align and insert the (4) support legs into the (4) support board housings until they “click” in place.
Attaching Power Housing to Front Base Leg 1 M6 Screw - 3.5cm - x2 - Actual Size Auto-Glide Housing Auto-Glide Housing M6 Screw Thread M6 Screw Thread THIS SIDE UP FACING INWARD Auto-Glide Housing Nub Attach (x2) M6 Screws Front Base Leg Auto-Glide Housing Front Base Leg FACING INSIDE • Locate the auto-glide housing, front base leg with power connection, two (x2) M6 x 3.5cm screws and a Phillips screwdriver. • Align the auto-glide housing nub post to the center hole inside the base leg.
Front Base Leg and Frame Assembly M6 Screw - 1.7cm - x2 - Actual Size BOTTOM & FRONT 1 FRONT BASE LEG MATTRESS SUPPORT BOARD P TO ONT FR BOTTO M & F RONT FRAME • Locate the two (x2) M6 screw, a Phillips screwdriver, and the front base leg. • Insert the two (x2) M6 screw to the assembled front base leg and use the Phillips screwdriver to tighten on both sides. NOTE: Align the front base leg so that the power housing is facing inside of the bassinet. Customer Service Tel. (646) 435-8726 8 www.
Back Base Leg and Frame Assembly 1 M6 Screw - 1.7cm - x2 - Actual Size BACK BASE LEG Align two side nubs to the three holes on frame MATTRESS SUPPORT BOARD BACK BASE LEG CK BA NOTE: You may need the help of another adult for assembly. FRAME Customer Service Tel. (646) 435-8726 • Locate the two (x2) M6 screw, a Phillips screwdriver, and the back base leg. • Insert the two (x2) M6 screw to the back base leg and use the Phillips screwdriver to tighten on both sides. P TO ONT R F 9 www.
Storage Basket Assembly 1 2 Slide Support Tube Into Fabric Storage Liner Fabric Storage Liner T ON R F T ON FR 1 Support Tube Fabric Storage Liner Facing Upward 3 Slip the corners fabric liner 2 over bottom base legs (4x). M6 Screw - 1.7cm - x2 - Actual Size • Locate the two (x2) support tubes, and the fabric storage liner. • Slide the support tubes into fabric storage liner on both sides. • Flip over the fabric storage liner with support tubes, facing upward.
Locking Casters Assembly 1 2 T ON R F T ON R F T ON R F *Once casters are assembled, turn the assembly bassinet upright. T ON R F T ON FR • Locate the four (x4) locking casters and insert into (4) bottom leg joints. • Insert the casters into the base legs. Push down until you hear the caster “CLICK” into place. • Pull upward on the caster to assure it is properly attached to the bassinet. Customer Service Tel. (646) 435-8726 11 www.DeltaChildren.
Consumer Information WARNING Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE. CAUTION - Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a class B digital device. pursuant to Part 15 of the FCC Rules.
Mobile Arm Unit Operation Rotate Mobile Toys Twinkling Lights Music AUTO GLIDE Music Volume Switch Auto Glide Night Light Off On Music Volume Switch Mobile Functions On / Off Mobile Functions On/Off Switch • Push the Mobile Functions On/Off button at the base of the mobile arm to turn on power. This is the main power switch to the mobile arm and also turns on the power LED on the Night Light button. The LED will stay on in the dark. Music Button • Press to start cycle of music.
Attaching Fabric 1 4 Mattress Pad With Sheet FRONT • Place the sheet over the mattress pad. • Place the covered mattress pad into the liner. • Locate the fabric liner. NOTE: Side of the frame has the mobile arm attachment holes and the front of the liner has the warning label. • Align the mobile arm with mobile attachment opening on the warning label end. • Place the liner onto the frame. Make sure warning is centered at the front of bassinet.
Mobile Assembly 1 3 A Screws B • Fit the mobile to the mobile arm. Push the mobile up firmly. HINT: To disassemble the mobile for storage, press the tab on the mobile arm and pull the mobile down. 4 • Remove two (x2) pre-installed screws from mobile arm. • Locate the pre-drilled holes on the bassinet frame and place the mobile arm over the holes on the bassinet side frame.
Wire Connection Assembly 2 1 MMobile obile Ar m Wir e Arm Wire with ctor WithConne Connector 2 TopBase Base Leg Top Leg Connection Cord Connection Cord Battery Wire withConnector 1 Magnet Wire Power Housing Wire Connection Conne ction Cord Battery Compartment Power Cord Fig. 3 1 2 Bottom Base Leg Connection Located On The Inside Of Base Leg Fig. 4 2 Fig. 1 • Locate the Power Cord. Insert underneath the fabric storage liner opening and plug into the Bottom Base Leg Connection. (Fig.
Care and Maintenance • The frame, mattress pad, storage basket, music module may be wiped clean using a mild cleaning solution and a damp cloth. Do not use bleach. Do not use harsh or abrasive cleaners. Rinse clean with water to remove residue. Do not immerse the frame. • The sheet is machine washable. Wash it separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly. • Always store product in a clean and dry place.
Customer Service Tel. (646) 435-8726 18 www.DeltaChildren.
Customer Service Tel. (646) 435-8726 19 www.DeltaChildren.
1-646-435-8726 www.DeltaChildren.
