Owner Manual

7
Customer Service Tel. [phone] www.DeltaChildren.com
Attaching Power Housing to Front Base Leg
1
M6 Screw - 3.5cm - x2 - Actual Size
THIS SIDE UP
FACING INWARD
Auto-Glide Housing
M6 Screw
Thread
Auto-Glide
Housing Nub
M6 Screw
Thread
Auto-Glide
Housing
• Locate the auto-glide housing, front base leg with power connection,
two (x2) M6 x 3.5cm screws and a Phillips screwdriver.
• Align the auto-glide housing nub post to the center hole inside the
base leg.
• Next using a Phillips screwdriver, tighten two (x2) M6 screws on
the opposite sides of the base leg.
• Pull outward on the auto-glide housing to make sure it is securely
attached.
Attach (x2) M6 Screws
FACING
INSIDE
Auto-Glide Housing fully
attached to front base leg
Front Base
Leg
Auto-Glide
Housing
Front Base
Leg