Paper Shredder User Manual

OPERATION

RC12 12/05 Operation Section 4-21

OPERATION

Always disengage the tractor differential lock when turning. When engaged the differential lock

will prevent or limit the tractor from turning. During normal cutting conditions, locking the

differential provides no benefit and should not be used.

Turning Procedure

Pull-type units - Pull-type units are fitted with an equal angle hitch to allow operating during turns. Do not

disengage PTO at end of row. Reduce speed and RPM slightly and proceed with turn. Make wide turns to

reduce load on driveline caused by high joint angles.

9.4 Driving the Tractor and Mower

Start off driving at a slow speed and gradually increase your speed while maintaining control of the tractor and

mower. Moving slowly at first will also prevent the tractor from rearing up and loss of steering control. The

tractor should never be operated at speeds that cannot be safely handled or which will prevent the operato

from stopping quickly during an emergency. If the power steering or engine ceases operating, stop the tracto

immediately as the tractor will be difficult to control.

Drive the tractor with the 3-Point lift arms in the raised position and lock the control lever in the transport detent

position to prevent damage to the mower driveline and tongue when turning.

Perform turns with the tractor and mower at slow

speeds to determine how the tractor with an

attached mower handles a turn. Determine the safe

speed to maintain proper control of the tractor when

making turns. When turning with a towed

implement, the overall working length of the unit is

increased. Allow additional clearance for the mower

when turning.

To avoid overturns, drive the tractor with care and at

safe speeds, especially when operating over rough

ground, crossing ditches or slopes, and turning

corners. Tractor wheel tread spacing should be

increased when working on inclines or rough

ground to reduce the possibility of tipping.

Use extreme caution when operating on steep

slopes. Keep the tractor in a low gear when going

downhill. DO NOT coast or free-wheel downhill.

OPS-F- 0018