User Manual

10


PORT
LOW VOLTAGE
POWER CABLE
2) BACK BOX
1/8" BEAD
SEALANT
1) TV ASSEMBLY
Step 3
Install TV Assembly:
A) Place TV assembly face down on a clean, dry surface near the installed back box. Make all necessary
connections and ensure LCD operation is successful.

engage. Ensure functionality in installed position.
C) Remove TV assembly from back box. Do not disconnect any wires. Clean any residue from glass and
remove debris.
D) Generously apply 1/8" bead of supplied waterproof sealant to glass face as close to the edge as possible.
 are fully engaged. Sealant should seep out the front on
all edges to provide the best seal.
E) Immediately after TV assembly is installed and sealed, again verify functionality of LCD and remote. If
operation has been compromised by the installation, corrections can easily be made before the sealant
has cured.
F) Wipe dripping or excessive sealant.
Scan to watch
the 2-minute
installation video
NOTE: THE POWER SUPPLY MUST NOT BE MOUNTED INSIDE A WALL CAVITY.
Installation