Installation Guide

INSTALLATION INSTRUCTIONS

External Media Compartment Installation Instructions

Compatible with Shade Series 2™ 55-inch, 65-inch, and 75-inch TVs

(models: SHD2-55, SHD2-65, SHD2-75)

TOOLS REQUIRED

Phillips Head #3 Screwdriver

Allen Wrench, 5/32-inches

1. Use a Philips #3 screwdriver to unscrew the four ¼-20 screws and remove the cover from the

External Media Compartment.

2. The hardware kit that includes two stake adapters and six screws will be located inside of the

External Media Compartment. Remove the hardware kit and place your desired media devices in the

compartment. Wires from the media devices should exit the media compartment by the foam gasket.

3. Use the four ¼-20 screws that were previously removed in step 1 to re-aach the cover to the

External Media Compartment

PAGE 1
INSTALL ATION INSTRUCTIONS External Media Compartment Installation Instructions Compatible with Shade Series 2™ 55-inch, 65-inch, and 75-inch TVs (models: SHD2-55, SHD2-65, SHD2-75) TOOLS REQUIRED Phillips Head #3 Screwdriver Allen Wrench, 5/32-inches 1. Use a Philips #3 screwdriver to unscrew the four ¼-20 screws and remove the cover from the External Media Compartment. 2. The hardware kit that includes two stake adapters and six screws will be located inside of the External Media Compartment.
PAGE 2
4. Locate the two stake pocket adapters and four screws that came in the hardware kit. Line up the stake pocket adapters with the correct set of holes on each wing. There are two sets of holes on each wing: the inside set of holes is for Shade Series 2™ 55-inch and 65-inch TVs and the outside set of holes is for the Shade Series 2™ 75-inch TV. Using an Allen wrench and the four provided screws, screw the stake pocket adapters in place.