Operation Manual

22
Power settings
Power (P) Display
Type
1 x 900 W P100 (100 %) High Heating up liquids, cooking
2 x 720 W P 80 (80 %) Medium high Defrosting and heating up deep-frozen dishes
3 x 450 W P 50 (50 %) Medium Cooking delicate food
4 x 270 W P 30 (30 %) Defrosting Defrosting
5 x 90 W P 10 (10 %) Low Defrosting delicate food
Example: To programme the microwave function for a cooking time of 5 minutes at 50% power.
1. Press
3 times. The display shows P 50 and .
2. Press or , until the display shows 5:00.
3. Press . The symbol starts fl ashing on the display.
Note: The following steps are used for setting the cooking time:
0 – 1 minute : 5-second steps
1 – 5 minutes : 10-second steps
5 – 10 minutes : 30-second steps
10 – 30 minutes : 1-minute steps
30 – 95 minutes : 5-minute steps
The hot-air function
With this function, hot air circulates inside the oven, achieving an even cooking and browning process. The pre-programmable
temperature range for this unit is between 140°C and 230°C. The temperature is set by using the keys and . The cooking
time can be pre-set to a maximum of 95 minutes.
If required, the appliance may also be pre-heated. Select the desired temperature level and press ‘Start’.
Example: The appliance is to be pre-heated to 200°C, followed by a cooking time of 30 minutes.
1. Press . 140°C starts fl ashing on the display, and the symbol appears.
2. Use the keys and to set the temperature to 200°C.
3. Press to confi rm the temperature setting.
4. Press to start the pre-heating process.
5. The symbol and the red indicator ‘200°C’ will fl ash while pre-heating is in progress. As soon as the pre-set temperature has been
reached, the red indicator ‘200°C’ stops fl ashing.
6. Open the door, place the food inside the oven compartment and close the door again.
7. Press or , until the display shows 30:00.
8. Press to start the cooking process. The symbol fl ashes on the display; during the heating process, the red indicator ‘200°C’.
appears as well.
Note: Steps 4 and 5 can be omitted, if pre-heating is not required.
The grill function
The grilling process uses radiation heat to process the food. This programme is suitable for cooking ‚au gratin‘ or for grilling thin
pieces of meat.
Select the desired grilling time. The grilling time can be pre-set to a maximum of 95 minutes. The power setting of the grill function
cannot be changed. As the meat needs to be turned after one side is suffi ciently browned, and taken out once it is done on both
sides, this process should be closely monitored.
Example: Programming the grill function for 30 minutes.
1. Press . 140°C starts fl ashing on the display, and the symbol appears.
2. Use the keys and to set the grill function. The indicator ‘G-1’fl ashes on the display; in addition, the symbol appears.
3. Press to confi rm the grill function.
4. Use the keys and to set the required cooking time.
5. Press to start the grill process. The symbol fl ashes on the display.