Instruction manual

GB
Connecting machine to power source
10
a
b
3
4
1
2
A
B
Caution:
Attention:
Always make sure that the machine is unplugged from power source
and the main switch is on "O". when the machine is not in use and
before inserting or removing parts.
Consult a qualified electrician if in doubt as to connect machine to
power source. Unplug power cord when machine is not in use.
The appliance must be used with the foot controller 4C-316B (110-
120V area)/ 4C-126G or 4C-326G (230V area)/ 4C-316C or 4C-326C
(220-240V area) manufactured by MATSUSHITA ELECTRIC
(TAIWAN) CO., LTD.
- This machine is equipped with a polarized plug which must be used
with an appropriate electrical outlet.
- Connect the machine to a power source as illustrated (1/2).
- The power switch is located above the terminal box. Your machine
will not operate unless this switch is on " I ". (1)
- Sewing light turns on automatically when the main switch is on " I ".
- To start the machine, press on the foot control (4). The speed of
the machine is regulated by the amount of pressure exerted on the
foot control.
a. Polarized attachment plug
b. Conductor intended to be grounded
IMPORTANT NOTICE
For appliance with a polarized plug (one blade is wider than the other).
To reduce the risk of electric shock, this plug is intended to fit in a
polarized outlet only one way. If it does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not modify the plug in any way. (3)