Instruction manual

GB
Attaching the presser foot holder
Attention:
Turn power switch to "O" before carrying out any of the
operations below.
Raise the needle to its highest position and raise the
presser foot lever. Attach the presser foot holder (b) to
the presser foot bar (a). (1)
Lower the presser foot holder (b) until the cut-out (c) is
directly above the pin (d). (2)
Lower the presser foot holder (b) and the presser foot (f)
will engage automatically.
Raise the presser foot.
Release the pressure foot by raising lever (e) located at
the back of the foot holder. (3)
Attach the seam guide (g) in the slot as illustrated. Adjust
the distance as required for hems, pleats, etc.... (4)
Attaching the presser foot:
Removing the presser foot:
Attaching the seam guide:
16
4
1
2
3
e
b
a
a
c
d
e
f
b
g