Instruction manual

Inserting bobbin

Attention:

Turn power switch to "O" before inserting or removing the

bobbin.

When inserting or removing the bobbin, the needle must be

fully raised.

- Open the hinged cover. (1)

- Hold the bobbin case with one hand. Insert the bobbin so

that the thread runs in a clockwise direction (arrow). (2)

- Pull the thread through the slot, down and to the left until it

enters the delivery eyelet (rectangular opening) under the

tension spring. (3)

- Hold the bobbin case by the hinged latch. (4)

- Insert the bobbin case fully into the shuttle race and release

the latch. Make sure that the metal finger fits into the notch

at the top of the race cover. (5)