Instruction manual

1~5

- Set the machine as illustrated.

- Remove the presser foot and the presser foot holder.

- Move the drop feed control to right side to lower the feed dogs.

(1)

- Lower presser foot lever before starting to sew.

- Adjust the stitch width according to the size of lettering or design.

- Draw the desired lettering or design on the right side of the

fabric.

- Stretch the fabric between embroidery hoop as firmly as

possible.

- Place the fabric under the needle. Make sure the presser foot

bar is down in its lowest position.

- Turn the balance wheel towards you to bring up the lower thread

through the fabric. Sew a few securing stitches at the starting

point.

- Hold the hoop with thumb and forefingers of both hands while

pressing the material with the middle and third fingers and

supporting the outside of hoop with smaller finger.

* Embroidery hoop not included with machine.

Preparation for Monogramming and Embroidering*

Monogramming and embroidering with embroidery hoop*