OWNER’S GUIDE MANUEL DU PROPRIÉTAIRE MANUAL DEL USUARIO NV652 NV652 NV652 ™ w w w . P o w e r e d L i f t A w a y. c o m 8 0 0.79 8.
READ ALL INSTRUCTIONS BEFORE USE Thank you for purchasing the Shark® Rotator™ Powered Lift-Away® Upright Vac. For a list of what is included with this model, refer to inside flap of box. This Owner’s Guide is designed to help you get a complete understanding of your new vacuum cleaner. Please read it carefully and keep it for future reference. If you should have a question about your Shark Rotator , please call the Shark® Customer service line at 800-798-7398.
LISEZ TOUTES LES INSTRUCTIONS AVANT L’UTILISATION LEA COMPLETAMENTE LAS INSTRUCCIONES ANTES DE UTILIZARLO CONSIGNES DE SÉCURITÉ IMPORTANTES Lorsque vous utilisez un appareil électrique, des précautions de sécurité de base devraient toujours être suivies, incluant celles qui suivent : AVERTISSEMENT POUR RÉDUIRE LE RISQUE D’INCENDIE, DE CHOCS ÉLECTRIQUES OU DE BLESSURES : 1 N’UTILISEZ PAS à l’extérieur ou sur des surfaces humides.
Deep Carpet 1 Place the nozzle on the floor and insert the wand. 2 Insert the handle into the wand. 3 Slide the POD onto the wand. 4 Attach the hose to the back of the pod. 5 Insert DUSTING GENIE and upholstery tool into the accessory clips as shown. UPRIGHT CLEANING ASSEMBLY 1 Press POWER and push the surface selector to THICK CARPET/AREA RUG for the best setting for High Pile and Thick Carpets, Area Rugs, and Specialty Carpets if the vacuum is difficult to push or pull due to high suction.
To clean with the hose, press the WAND or HANDLE release button (depending on the amount of reach required) then lift handle up. 6 Insert wand or handle directly into desired tool. LIFT-AWAY CLEANING ABOVE FLOOR CLEANING ™ Use for portable cleaning on stairs or anywhere 1 Press LIFT-AWAY to lift the pod off the wand. BARE FLOOR CLEANING 2 To clean with hose, press the WAND or HANDLE release button then lift handle up.
CANISTER CLEANING Convert your upright to a convenient canister 1 From the Lift-Away™ mode, place the pod onto the canister caddy. 3 Press the WAND release button, lift the handle up and attach preferred accessory. 2 Cleaning in POWERED Lift-Away™ mode allows you to still use the motorized floor nozzle. 4 Use the posts on the caddy to store additional cleaning accessories.
Hard Floor POWER BUTTON suction. If the vacuum is difficult to push or pull on certain carpets or area rugs, you can either disengage the brush roll and use the suction only setting or switch the surface selector to Thick Carpet/Area Rug mode. 1 The POWER button turns the vacuum on. Carpet SURFACE SELECTOR HELPFUL TIPS Deep Carpet 2 Selecting the Hard Floor setting will stop the brushroll from spinning and allow you to clean bare floor and above floor surfaces with ease.
CLEAN THE FILTERS See cleaning schedule on page 2 EMPTY THE DUST CUP 1 Pull up on the dust cup release latch and lift the dustcup off the pod. 2 Holding the dust cup over a garbage bag or can, press the bottom empty release latch. MAINTENANCE 3 Press the top dust cup release latch to access the dust screen and remove built-up debris as required. MAINTENANCE 4 With the dust cup removed, remove and rinse the foam and felt filters every 3 months. Let air dry completely before replacing.
CHECK FOR BLOCKAGES 2 BOTTOM OF FLOOR NOZZLE REMOVE AND INSPECT: 1 HOSE AND TUBES MAINTENANCE Remove floor nozzle and extension wand and shine a flashlight up from the bottom to check for possible blockage. Remove dustcup and hose to check intake opening and hose elbow. a Using a coin, turn the locking screws to the unlock position and pull up to expose the airway. Remove any obstructions, close and relock. Vacuum is not picking up dirt.
TROUBLESHOOTING GUIDE Vacuum turns off on its own • If the hose connection is not properly latched, it can cause a poor electrical connection and the hose can come loose and power vacuum OFF. 1. Turn the unit off; unplug the vacuum. 2. Empty the dust cup and clean filters. 3. Check for blockages in hose, accessories and inlet openings. 4. Remove cord from cord hook so hose latch can be seen and engaged. Reassemble. 5.
EURO-PRO Operating LLC Newton, MA USA 02459 Ville St. Laurent, Québec Canada H4S 1A7 NV652.40.E.F.S.150123.10 © 2015 Euro-Pro Operating LLC Illustrations may differ from actual product. We are constantly striving to improve our products, therefore the specifications contained herein are subject to change without notice. Les illustrations peuvent différées du produit réel. Nous essayons constamment d’améliorer nos produits, donc les clauses contenues dans ce document peuvent changer sans préavis.
