OWNER’S GUIDE S3550
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS For Household Use Only WHEN USING YOUR SHARK STEAM MOP, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS BEFORE USING YOUR STEAM MOP. DANGER OF SCALDING. Please use caution when using the steam mop. The steam emitted from the steam mop is very hot. POLARIZED PLUG: This appliance has a polarized plug (one blade is wider than the other).
English 11. DO NOT unplug by pulling on power cord. To unplug, grasp the plug not the power cord. Do not use extension cords or outlets with inadequate current carrying capacity. 12. DO NOT put any objects into openings. Do not use with any opening blocked. 13. DO NOT put hands or feet under the steam mop. Unit gets very hot. 14. Use ONLY on flat, horizontal surfaces. Do not use on walls, counters or windows. 15.
Quick Start When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark® Steam Mop. 1 2 3 1 4 ASSEMBLE Insert the mop handle into the pump actuator (the tube that leads to the tank). Push the mop handle and pump actuator together in until you hear it click into place. 2 Select a mop head and cleaning pad.
QUICK TIP: For easier pushing and pulling, extend the handle length DIRT CAN’T HIDE ON EITHER SIDE! All new design allows for optimal cleaning! When one side of the pocket gets dirty, just turn the mop head over and clean with the other side of the pocket. 6 5 6 PREPARE For your comfort, you can adjust the height of the mop. Just lift the latch on the tube 90 degrees to the open position. Holding the handle, extend the tube to the height that’s right for you and then close latch to locked position.
TECHNICAL SPECIFICATIONS Voltage: 120V., 60Hz. Power: 1550 Watts Water Capacity: 450 ml (15 oz.
English Contents Thank you for purchasing the Shark® Steam Pocket Mop. Getting Started................................................................................. 2 Using Your Steam Mop.................................................................. 5 Using Your Carpet Glider.............................................................. 7 Care of Your Steam Mop............................................................... 8 Ordering Replacement Parts ..............................................
Getting Started When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark® Steam Pocket Mop.
English 1 2 3 1 2 ASSEMBLE Insert the mop handle into the pump actuator (the tube that leads to the tank). Push the mop handle and pump actuator together in until you hear it click into place. 3 Snap the mop head into the base to secure it. Press the release button to exchange mop heads. Select a mop head and cleaning pad. Fit one side of the pocket onto the head first, then using the lavender loop, pull the pocket over the head.
Getting Started - cont’d IMPORTANT: First things first, always make sure the mop is UNPLUGGED from the wall when not in use. Never fill the mop, attach the mop head, change or remove the micro-fiber pocket when the mop is plugged into the wall. If you have hard water you might want to use distilled water to prolong the life of the Shark® Steam Mop. Make sure you only add water to the tank. Chemicals or cleaning solution may damage the appliance and could be unsafe for you and your family.
Using Your Steam Mop English IMPORTANT: Make sure you don’t use the mop without attaching a micro-fiber pocket and adding water to the tank first. When you are using the mop for the first time, it might take longer than the normal 30 seconds to start steaming. Just pump the handle a few times in a downward motion to prime the pump and it should be ready. 2 1 NOTE: Make sure the floors are swept or vacuumed before using the steam mop.
Using Your Steam Mop - cont’d 4 3 3 For your comfort, you can adjust the height of the mop. Just lift the latch on the tube 90 degrees to the open position. Holding the handle, extend the tube to the height that’s right for you and then close latch to locked position. 4 When one side of the micro-fiber pocket gets dirty, just flip the mop head and you can quickly start using the other side. Dirt can’t hide on either side.
English Using Your Carpet Glider The Steam Mop won’t clean your carpeting or area rugs. However, it’s great for deodorizing and freshening. 1 THE CARPET GLIDER 1 The Carpet Glider can be used with the rectangle mop head to lightly steam your carpet and area rugs. Just place the mop head on top of the glider and move back and forth across a section of the carpet. The steam mop won’t clean your carpeting or areas rugs, but it’s great for deodorizing and freshening.
Care of Your Steam Mop AFTER USE AND STORAGE 1 When you have finished using the steam mop, and your floors are clean, unplug the cord from the outlet and move it into an upright position. Let the unit cool 2-3 minutes and release steam by pumping the handle several times before removing the microfiber cleaning pocket from the mop head.
English 2 1 KEEPING YOUR MICRO-FIBER CLEANING POCKET AS GOOD AS NEW 1 We recommend washing your microfiber pockets separately from other fabrics to avoid picking up lint. 2 If there are loose threads on the pocket carefully cut the thread with scissors. Don’t pull on them or cut at the base. Only use liquid detergent. (no powder detergent) Don’t use any fabric softeners or bleach. Line dry or dry on a low dryer setting. www.sharkclean.
Ordering Replacement Parts 1 3 2 4 5 6 7 ORDERING REPLACEMENT PARTS To order additional parts and accessories, feel free to contact us at www.sharkclean.com or call 1-800-798-7398. PART 1 (2) XL Cleaning Pads 2 (2) All-Purpose Cleaning Pads 3 (2) Steam Duster Cleaning Pads TOLL FREE: 1-800-798-7398 XLT3501 XT3501 XT3501SD 4 Rectangle Mop Head 1024SO 5 Triangle Mop Head 1025SO 6 XL Rectangle Mop Head 1023SO 7 Carpet Glider 10 PART NO.
Troubleshooting Guide PROBLEM The Steam Mop will not turn on. English POSSIBLE REASONS & SOLUTIONS Your Steam Mop should be securely plugged into a 120V AC electrical outlet only. Check your fuse or breaker. If your unit still doesn’t work, give us a call 1-800-798-7398 Steam Mop will not make steam. Steam Mop leaves water on the floor. Prime the pump, see page 5 for more information. Is there water in the water tank? If not, add water to your Steam Mop following the instructions.
Notes 12 TOLL FREE: 1-800-798-7398
English ONE (1) YEAR LIMITED WARRANTY EURO-PRO Operating LLC warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusions and exceptions. If your appliance fails to operate properly while in use under normal household conditions within the warranty period, return the complete appliance and accessories, freight prepaid.
U.S.: EURO-PRO Operating LLC Newton, MA 02459 Canada: EURO-PRO Operating LLC 4400 Bois Franc Ville St. Laurent, Québec H4S 1A7 1-800-798-7398 www.sharkclean.com COPYRIGHT© EURO-PRO OPERATING LLC 2009 PRINTED IN CHINA REV. 091021 Illustrations may differ with actual product.
