Operator`s manual

9.800-079.0 • Rev. 04/09
7
PRESSURE WASHER
OPERATOR’S MANUAL
ASSEMBLY INSTRUCTIONS
STEP 1: Attach the high
pressure hose to the spray
gun using teflon tape on hose
threads.
STEP 3: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure it
is seated properly.
STEP 5: Connect the high pressure
hose to the pump discharge fitting. Push
coupler collar forward until secure.
STEP 2: Pull the spring-loaded collar
of the wand coupler back to insert your
choice of pressure nozzle.
STEP 6: Connect garden hose to the
cold water source.
STEP 7: Connect the garden hose
to pump water inlet. Inspect inlets.
CAUTION: Do not run the pump
without water or pump damage
will result.
Safety
Latch
Spray
Gun
High Pressure
Hose
Wand
Coupler
Soap
Nozzle
Pressure
Nozzle
Wand
Coupler
Wand
Collar
Discharge Fitting
High Pressure Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden
Hose
Coupler Collar
DipStick
STEP 4: Remove shipping cap
and install oil dipstick. Check
pump oil level by using dipstick
or observe oil level in oil win-
dow (if equipped). Use 30 wt.
non detergent oil.
Oil Window