Install Instructions
ii
ii
• Connects COPPER, CPVC, PEX and PE-RT pipe in any combination
• SharkBite and SharkBite 2XL are Quick Connect and Quick Disconnect
• NO soldering, clamps, unions, glue or tools
• Certifi ed to 200 psi and 200°F
• Certifi ed for underground
*
and behind the wall applications and as a manufactured joint without access panels
• Exceeds ASSE 1061 Section 1V, 4.1 Materials - Dezincifi cation (DZR) - ISO 6509
• Certifi ed for potable water and hydronic applications
• Integral PEX Sti ener (3/8" to 1"), 1/4" is not required
• 2XL PEX Sti eners sold separately
• Fittings can be rotated after assembly for easier installation in tight places
• 1/4" push-fi t connector ends require use of 3/8" OD CTS PEX, CPVC or hard drawn Type K, L and M and annealed Type M copper
• Chrome-plated copper cannot be used unless chrome is removed
• Always consult with local plumbing codes concerning specifi c applications
*Fitting should be wrapped with an impervious material, chloride-free tape or tightly wrapped and sealed insulation works well to prevent direct contact with the
backfi ll. Backfi ll should be free of rocks, debris or any sharp objects that may cause damage through impact or abrasion.
www.sharkbite.com
THERE IS ONLY ONE
TRUE SHARKBITE
The Very Best in Push-Fit Plumbing Solutions
CUT:
Cut the pipe square
removing rough edges and
debris. Mark the pipe to the
correct insertion depth.
PUSH:
Push pipe and fi tting
together up to the
depth mark.
DONE.
*Using the disconnect
clip, fi ttings can
be easily changed,
removed and reused.
SHARKBITE
®
FITTINGS / TUBE SIZE COMPATIBILITY / PIPE INSERTION DEPTH
Nominal Size of Fitting Nominal Size of Tubing Tubing OD Size Tubing ID Size Pipe Insertion Decimal Depth Fraction
1/4" 1/4" CTS 3/8" 0.305" 0.81" 13/16"
3/8" 3/8" CTS 1/2" 0.350" 0.94" 15/16"
1/2" 1/2" CTS 5/8" 0.475" 0.95" 15/16"
5/8" 5/8" CTS 3/4" 0.652" 1.13" 1-1/8"
3/4" 3/4" CTS 7/8" 0.671" 1.13" 1-1/8"
1" 1" CTS 1-1/8" 0.885" 1.32" 1-5/16"
1-1/4" 1-1/4" CTS 1-3/8" 1.055" 2.0" 2"
1-1/2" 1-1/2" CTS 1-5/8" 1.245" 2.25" 2-1/4"
2" 2" CTS 2-1/8" 1.629" 2.50" 2-1/2"
1/4" compression 1/4" ACR 1/4" 0.190" n/a
3/8" compression 3/8" ACR 3/8" 0.311" n/a
1/2" SharkBite End
15/16"
Pipe
Insertion Depth