Operation Manual, User's Manual

1-130
BEFORE USING THE MACHINE►HOW TO PLACE THE ORIGINAL
PREVENTIVE LIGHT TO INDICATE
ORIGINAL LEFT BEHIND
In order to prevent originals being left behind, the automatic document feeder incorporates a lamp on the top of the
original exit tray.
This lamp detects a document on the automatic document feeder, and starts blinking after the last original is output from
the original exit tray.
Light turning off
The preventive light to indicate original left behind will turn off in the event of the following.
When the scanned original is removed
After the preventive light to indicate original left behind blinks three times, repeated three times
When a new original is placed in the automatic document feeder, and a job started
When the machine enters sleep mode
When use of the automatic document feeder is prohibited
When the preventive light to indicate original left behind is blinking, placing the original on the document glass will not turn
off the preventive light to indicate original left behind.
The preventive light to indicate original left behind will not turn off by only placing an original on the automatic document
feeder.
The preventive light to indicate original left behind will not turn off even if the operation panel is off.
If the preventive light to indicate original left behind turns off, this will not flash even if an original is left on the automatic
document feeder.
Preventive light to indicate original left behind ON/OFF settings
In "Settings (administrator)", select [System Settings] → [Common Settings] → [Device Control] → [Status Indicator Setting]
→ [Use Preventive Light to Indicate Original Left Behind].