Operation Manual, User's Manual

2-5
COPIER►BEFORE USING THE MACHINE AS A COPIER
COPYING SEQUENCE
This section explains the basic procedure for copying. Select settings in the order shown below to ensure that the copy
operation takes place smoothly.
For detailed procedures for selecting the settings, see the explanation of each setting in
this chapter.
You can also restore the default copy settings before executing copying
In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Condition Settings] → [Auto Clear Before Copy
Execution Also].
Enables the Auto Clear function during copy even when a copy job is not completed. This protects the machine from being held
due to the incomplete copy job.
1
Switch to copy mode.
► SELECTING COPY MODE (page 2-4)
2
Place the original.
Place the original in the document feeder tray of the
automatic document feeder, or on the document glass.
► AUTOMATIC DOCUMENT FEEDER (page 1-127)
► DOCUMENT GLASS (page 1-131)
Display Warning Message when Original is not Detected
In "Settings (administrator)", select [System Settings] → [Copy Settings] → [Condition Settings] → [Display Warning
Message when Original is not Detected].