Owner`s manual
6
118 1/4”
93 1/2”
1
Site Selection
8’
8’
10’
10’
Wherever possible you should use the surfaces described above. When this is not possible, we
recommend you use one of the following options:
Alternate Site Preparation
OPTION 1: Wood Platform
Be sure you use lumber that is treated and approved for
outdoor use. Build outside frame to 93 1/2” x 118 1/4” outside
dimensions:
1a
Item Qty.
2” x 4” x 90 1/2” treated board* 8
2” x 4” x 118 1/4” treated board* 2
48” x 93 1/2”’ Plywood (ACX)** 2
22 1/4” x 93 1/2” Plywood (ACX)** 1
16d 3” common nails 32
8d 1 1/2” common nails 36
* All lumber must be rated for outdoor use.
** Trim 4’ x 8’ sheets to this size.
Surface must be leveled before installation. If
the surface is not properly leveled, the outdoor
shed will not assemble or function correctly.
Proper surface leveling will save you time in the long
run, so please do not ignore this step.
Place the 2” x 4” x 90 1/2” boards
on the inside of the frame. Nail each
board in place with the 16d nails.
15.25”
16”
16”
16”
16”
16”
To be sure to have studs
in the correct location to
nail plywood in the next
step, start measuring here
& measure from center to
center.
Note: Any platform or similar structure should be built above ground in order to avoid water pooling inside shed.
NOTICE: Shed Extension Kits are available for this shed.
Please consider possible shed expansion when planning the
site for your shed. See inside the back cover of this manual for
information on ordering Extension Kits.
The actual dimensions of your shed (at its widest and longest points) are 8’ x 10’. Be sure
to select a site that will accommodate these measurements. The base of the shed is
slightly smaller than this, so you will need to create a level surface that is at least 93.5” x
118.25”. We recommend using a level cement or patio style surface. This will provide the
best long-term performance for your shed.
118.25”
93.5”