User Manual

Setup

Entering SETUP MENU

Connect AN-LS1 to a computer using RS-232C or Telnet, and open the “SETUP MENU” on the computer

to carry out various settings for AN-LS1.

When Connecting Using RS-232C

1 Launch general purpose terminal emulator.

2 Set settings for the RS-232C port of the terminal emulator as follows.

Baud Rate : *9600 bps

Data Length : 8 bit

Parity Bit : None

Stop Bit : 1 bit

Flow Control : None

* This is the default value. If the value of Baud Rate for AN-LS1 has been changed, set Baud Rate

here according to the changed value on AN-LS1. (Page 19)

3 Connect the plug for the AC adapter to a wall outlet to supply the power while holding

down the “A” (or “a”) key on the terminal keyboard.

4 Keep holding down the “A” (or “a”) key for more than 3 seconds. “Setup Menu Enable”

will be displayed.

5 Press the return key on the terminal keyboard.

6 Input “setup” and press the return key.

7 “User Name:” is displayed. Input the user name and press the return key.

(If a user name has not yet been set, just press the return key.)

8 “Password:” is displayed. Input the password and press the return key.

(If a password has not yet been set, just press the return key.)

9 Input “setup” and press the return key.

| SETUP MENU will be displayed.

S E T U P M E N U

[1]IP Address [2]Subnet Mask [3]Default Gateway

[4]User Name [5]Password

[6]RS-232C Baud Rate [7]Unit Name

[A]Advanced Setup [D]Disconnect All

[V]View All Setting [S]Save & Quit [Q]Quit Unchanged

setup>

• User name and password are not set in the initial settings.

• If the user name or password is entered incorrectly three times, SETUP MENU will be quit.