User Manual

ADVANCED SETUP MENU

******************** ADVANCED SETUP MENU ***********************

[1]Auto Logout Time [2]COM Redirect Port [3]Busy Reply

[4]Input Hold Time [5]Network Ping Test

[6]Accept IP Addr(1) [7]Accept IP Addr(2) [8]Accept IP Addr(3)

[9]Accept All IP Addr [0]Port for Search

[!]Restore Default Setting

[Q]Return to Main Menu

advanced>

[1] Auto Logout Time (Factory default setting : 5 minutes)

Setting of time until automatic disconnection of network connection. (

Page 21)

[2] COM Redirect Port (Factory default setting : 10002)

Setting of TCP port No. capable of connecting using Sharp COM Redirection Software. (Page 21)

[3] Busy Reply (Factory default setting : ERR + <CR> code)

When separate devices are connected to the two control terminals (RS-232C (CONTROLLER)

and 10BASE-T), it is not possible to use one control terminal while data is being transmitted using

the other control terminal.

This setting is for operation of the control terminal that cannot be used.

(Page 22)

[4] Input Hold Time (Factory default setting : 1000 milliseconds)

Changing value for Input Hold Time when a response is not returned from a projector within a set

time while separate devices are connected to the two control terminals (RS-232C (CONTROLLER)

and 10BASE-T). (Page 22)

[5] Network Ping Test

It is possible to confirm that a network connection between AN-LS1 and a computer etc. is working

normally. (Page 23)

[6] Accept IP Addr(1)

[7] Accept IP Addr(2)

[8] Accept IP Addr(3)

[9] Accept All IP Addr (Factory default setting : Accept All)

For improved security, it is possible to set up to three IP addresses allowing connection to AN-

LS1. Set IP addresses can be cancelled using [9] Accept All IP Addr. (Page 23)

[0] Port for Search (Factory default setting : 5006)

Setting for port number used when Sharp COM Redirection Software searches for AN-LS1. (Page

24)

[!] Restore Default Setting

Restores all setting values that can be set using the menu to the default state.

(Page 24)

[Q] Return to Main Menu

Return to the main SETUP MENU. (Page 24)