User Manual

28
6 Enter a check mark against Virtual COMs to be added to the computer and click
“OK”.
• It is necessary to add the same number of Virtual COMs as the number of these units used.
• If “Cancel” is clicked, the Sharp COM Redirection Software Driver is not installed. If you want to
install later, run Sharp COM Redirection Software using “Add or Remove Programs”.
When the “Hardware Installation” dialog box is displayed, click “Continue Anyway”. This dialog box
may appear a couple of times.
7 When the installation procedure is successfully completed, the “InstallShield Wizard
Complete” message will be displayed. Click “Finish” to restart the computer.