Service manual

Quick Reference Guide: AR-M207, M165, M162

Simulaltions

Simulations

Entering the Simulation Mode

Perform the following procedure to enter the simulation mode:

# key → * key → C key → * key →

Main code → Start key → Sub code → Start key

Canceling the Simulation Mode

To cancel the simulation mode, press the CLEAR ALL key.

Important: After canceling the simulation mode, be sure to

turn the power OFF/ON and check the operation.

When the interruption key is pressed, the process is interrupted

and the screen returns to the sub code entering display.

Note 1: If the machine is terminated by a jam error or paper

empty error during copying in the adjustment by the simulation,

recopying is required.

Note 2: The values in the simulation columns are not default

values but sample values.

List of Simulations