AR-M200/M201 Operation-Manual Setup-Guide GB

11
1
SETTING UP BUTTON MANAGER
Button Manager is a software program that works with the scanner driver to enable scanning from the machine.
To scan using the machine, Button Manager must be linked with the destination that appears in the display. Follow
the steps below to link Button Manager to scanner events.
Windows XP/Vista
1
Click the "Start" button, click "Control
Panel", click "Hardware and Sound",
and then click "Scanners and
Cameras".
In Windows XP, click the "start" button, select
"Control Panel" and click "Printers and Other
Hardware", and then click "Scanners and
Cameras".
2
Click the "SHARP MX-xxxx" icon and
select "Properties".
In Windows XP, select "Properties" from the
"File" menu.
3
In the "Properties" screen, click the
"Events" tab.
4
Select "SC1:" from the "Select an
event" pull-down menu.
5
Select "Start this program" and then
select "Sharp Button Manager W"
from the pull-down menu.
6
Repeat Steps 4 and 5 to link Button
Manager to "SC2:" through "SC6:".
Select "SC2:" from the "Select an event"
pull-down menu. Select "Start this program",
select "Sharp Button Manager W" from the
pull-down menu. Do the same for each
ScanMenu through "SC6:".
7
Click the "OK" button.
Button Manager is now linked to the machine
scan destinations SC1: to SC6:.
The scan settings for each of scan destinations
SC1: through SC6: can be changed with the
setting window of Button Manager.
For the factory default settings for destinations
SC1: to SC6: and the procedures for configuring
Button Manager settings, see "BUTTON
MANAGER SETTINGS" in "Operation Manual
(for printer and scanner)" in the "Software
CD-ROM" that accompanies the machine.