AR-M200/M201 Operation-Manual Setup-Guide GB

13
2
INSTALLING THE SOFTWARE
(FOR OPTIONS)
The procedures for installing the software when the machine is used as a network printer using the optional network
expansion kit (MX-NB10) are explained in this chapter.
SETUP IN A WINDOWS
ENVIRONMENT
HARDWARE AND SOFTWARE
REQUIREMENTS
Before installing the software, see "HARDWARE AND SOFTWARE REQUIREMENTS" on page 36 to make sure
your computer meets the hardware and software requirements.
SETTING THE IP ADDRESS OF THE
MACHINE
Before installing the printer driver, be sure to set the IP address of the machine as explained in "System Settings" in
the "Network Printer" manual on the CD-ROM. Consult your network administrator for the correct IP address, subnet
mask, and default gateway to be entered. If a DHCP server will automatically assign an IP address to the
machine, the following procedure is not necessary. (To check the IP address assigned to the machine by
DHCP, see "CHECKING THE IP ADDRESS" (page 36).)
If the machine is used in a DHCP environment, the machine's IP address may change
automatically. If this happens, printing will no longer be possible. In this event, use a WINS
server or do not use the machine in a DHCP environment.
Caution