AR-M200/M201 Operation-Manual Setup-Guide GB

36
CHECKING THE IP ADDRESS
There are several settings where the IP address must be entered or checked.
To check the IP address of the machine, hold down the status button on the network expansion kit for at least 2
seconds to print out a Printer Setting List.
HARDWARE AND SOFTWARE
REQUIREMENTS
Before installing the software from the CD-ROM that is provided standard with the machine or the CD-ROM that is
provided with the optional network expansion kit (MX-NB10), make sure that your computer satisfies the following
requirements.
*1 Administrator's rights are required to install the software.
*2 Sharpdesk is not supported. The MFP driver, Button Manager, and other software on the "Software CD-ROM" that is provided
standard with the machine are not supported.
*3 The machine's USB 2.0 port will transfer data at the speed specified by the USB 2.0 (Hi-Speed) standard only if the Microsoft
USB 2.0 driver is preinstalled in the computer, or if the USB 2.0 driver for Windows 2000 Professional/XP/Vista that Microsoft
provides through "Windows Update" is installed.
*4 Compatible with models preinstalled with Windows 2000 Professional, Windows XP Professional or Windows XP Home
Edition or Windows Vista and which are equipped standard with a USB interface.
HOW TO RESET THE NETWORK EXPANSION KIT
To reset the network expansion kit, power on the machine while holding down the status button on the network
expansion kit.
After the network expansion kit is reset, network scanner destination information and scan settings will remain,
however, the network settings and network printer settings will revert to the factory default settings.
Windows (standard
machine system)
Windows (options) Macintosh (options)
Operating system Windows 2000 Professional*
1
, Windows XP Professional*
1
,
Windows XP Home Edition*
1
, Windows 2000 Server*
1,2
,
Windows Server 2003*
1,2
, Windows Vista*
1
,
Windows Server 2008*
1,2
Mac OS 9.0 to 9.2.2,
Mac OS X v10.2.8,
Mac OS X v10.3.9,
Mac OS X v10.4.11,
Mac OS X v10.5 to
10.5.6
Computer type IBM PC/AT compatible computer
An environment on
which any of the
operating systems listed
above can fully operate
(including Macintosh
computers with an Intel
processor).
Equipped standard with a
USB 2.0*
3
/1.1*
4
port
Equipped with a
10Base-T/100Base-TX LAN
board
Display 1024 x 768 dots resolution and 16-bit colour or higher is
recommended.
Other hardware
requirements
An environment that allows any of the above operating systems to fully operate
Status button
Caution