Operation Manual, Troubleshooting

12
General Problems
THE DISPLAYED TRAY PAPER SIZE IS NOT
CORRECT
Check Solution
Is the paper size loaded to the bypass
tray same with the paper size being
displayed in the touch panel?
■ Set the "Tray Settings" setting on the home screen and change to the paper size
loaded with the paper size setting of the bypass tray.
THE ORIGINAL MISFEEDS (AUTOMATIC DOCUMENT
FEEDER)
Check Solution
Is too much paper loaded into the
document feeder tray?
■ Make sure that the stack of paper in the tray is not higher than the indicator line.
► Placi
ng the original and adding paper (page 5)
Is the original a long original? ■ When using the automatic document feeder to scan a long original, set the scan
size to [Long Size].
(Note that long originals cannot be copied using the copy function.)
Is the original on thin paper? ■ Use the document glass to scan the original.
If you need to use the automatic document feeder, use [Slow Scan Mode] in
[Others] to scan the original.
(MX-B456W/MX-B456WH/MX-B476W/MX-B476WH)
Is the feed roller dirty? ■ Clean the surface of the paper feed roller.
► Main
tenance (page 6)
?
!
?
!