OPERATION MANUAL

40
E
RS-232C command table
How to read the command table
Command: Command field (See page 38.)
Direction: W When the “Parameter” is set in the parameter field (see page 38), the command functions as described
under “Control/Response Contents”.
R The returned value indicated under “Reply” can be obtained by setting “????” or “
?” in the
parameter field. (See page 38.)
Parameter: Parameter field (See page 38.)
Reply: Response (Returned value)
TIPS
• Inthestandbystate,theonlycommandthatisusedisPowercontrol.
Power control/Input mode selection/Brightness adjustment
Function Command Direction Parameter Reply Control/Response contents
Power control POWR W 0 Switches to standby state.
1 Returns from standby state.*
R 0 Standby state
1 Normal mode
Input mode selection INPS W 0 Toggle change for input mode.
2 D-SUB
3 YPBPR
4 AV
10 HDMI 1
13 HDMI 2
18 HDMI 3
21 OPS
“ERR” when nothing is attached in the expansion slot.
24 APPLICATION
R 2 D-SUB
3 YPBPR
4 AV
10 HDMI 1
13 HDMI 2
18 HDMI 3
21 OPS
24 APPLICATION
Brightness adjustment VLMP WR 0-100 0-100
* You can use “Wake On LAN (Magic Packet)” to turn on the power via LAN.
It is not possible to turn on the monitor with the IP Control command.
Picture menu
Function Command Direction Parameter Reply Control/Response contents
Aspect Ratio (Screen size selection) WIDE W 0 0 Toggle change for screen size.
WR 1-5 1-5 1: 16:9, 2: Dot by Dot, 3: 4:3, 4: Zoom1, 5: Zoom2
Sound menu
Function Command Direction Parameter Reply Control/Response contents
VOLUME VOLM WR 0-100 0-100
MUTE AUDIO MUTE WR 0-1 0-1 0: OFF, 1: ON
Controlling the Monitor with a computer (RS-232C)