Specifications

Fan
The fan will automatically start when heat rises from range surface units or burners. This protects the microwave oven from
excessive temperature rise, Thefan wilt stayon untilthe temperaturedecreases,,Itcannotbeturned off manually during thistime,,
For other uses, select either Hi or LO speed..
PRECAUTIONS FOR PROPER USE:
1. DO NOT leave range unattended while using high temperatures. Automatic fan may start and provide excessive air tothe
surface units. This may cause spattering or believer.
2 Avoid burning food.
3.. Keep grease filters clean.
Light
1o To replace lightbulbs, first disconnect power to the oven at
the circuit breaker panel or by unplugging..
2. To release cover remove the screw on the light cover. (See
illustration.)
3., Replace bulbs only with Sharp Part Number
RLMPTAO36WREO available from a Sharp Servicer or
equivalent 30 watt bulb available at most hardware stores or
lighting centers.. DO NOT USE A BULB LARGER THAN 30
WATTS.
4o Close lightcover and secure with screw removed in step 2._
CAUTION: Light cover may become very hot. Do not touch
glass when light is on_Do not use light for long time
use such as a night light.
i_ •
/
t.ight cover
Screw
Light bulbs
Charcoal Filter Kit
Charcoal Filter Kit, Sharp Part Number RK-220 is used for non-
vented, recirculated installation. The filter should be changed
every6 to 12 months depending on use.
1. Disconnect power to the oven at the circuit breaker panel or
by unplugging.
2, Remove three louver mounting screws° (See illustration,)
3. Pull the louver away from the uniL
4, Change the charcoal filter,
5o Push louver back in place and replace the screws,,
Charc_ilte ___
Louver Mounting
Louver Screws
Oven Light
Remove the louver per instructions 1 - 3 above and charcoal filter, ifused,
4. Remove and save one Phillips head screw from oven light cover.
5. Remove old light bulb and replace only with Sharp Part Number RI,MPTAO3OWREO available from Sharp Servicer, or
equivalent 20 watt light bulb available from most hardware stores and lighting centers. DO NOT USE BULB LARGER
THAN 20 WATTS°
6. Replace the oven light cover, Phillips head screw and charcoal filter, if used; push louver back in place and replace the
louver mounting screws.