User Manual

CD-DV999W
E-66
ENGLISH
Advanced Features
4
CD-DV999W (Z)
TINSZA017AWZZ
H Digital connection to a Dolby digital, DTS/MPEG
audio processor or MD recorder
You can record sound on a digital audio recorder by connecting to the digital
audio output socket using an optical digital cable.
When connecting a digital audio recorder to the digital audio output socket,
set the “
DIGITAL/MPEG” to “D-PCM/PCM” (see page 24).
BIT STREAM For 5.1 channel Dolby Digital/DTS surround processors, etc.
D-PCM/PCM For 2 channel digital input amplifiers, etc.
Note:
Some discs are copy protected and digital recording is not possible (including
DTS signals).
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service
technician.
If something is wrong with this product, check the following before calling your
authorised SHARP dealer or service centre.
H General
Symptom
● The clock is not set to the
correct time.
● When a button is pressed,
the unit does not respond.
● No sound is heard.
Possible cause
● Did a power failure occur?
Reset the clock. (Refer to page 16.)
● Set this unit to the power stand-by mode
and then turn it back on.
● If the unit still malfunctions, reset it.
(Refer to page 68.)
● Is the volume level set to “0”?
● Are the headphones connected?
● Are the speaker wires disconnected?
● Is the Karaoke mode set to “L-CH”, “R-
CH” or “V-CANCEL”?
H Remote control
Symptom
● The remote control does not
operate.
Possible cause
● Is the AC power lead of the unit plugged
in?
● Is the battery polarity correct?
● Are the batteries dead?
● Is the distance or angle incorrect?
● Does the remote control sensor receive
strong light?
To the digital
input socket
Optical digital lead
(not supplied)
Dolby digital, DTS/MPEG
audio processor or
MD recorder
An optical digital cable is not supplied.
Purchase an optional optical digital cable.
References
*DV999W_EP61-66 04.3.4, 17:5066