Specifications

TROUBLESHOOTING
–
20
–
EN
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the
system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair.
Problem Solution
No power –Check if the AC power cord is properly connected.
No picture –Check if the TV is switched on.
–Check the video connection
Distorted picture –Sometimes a small amount of picture distortion may appear .This is
not a malfunction.
Completely distorted picture or –Connect DVD player directly to the TV.
black/white picture with DVD –Make sure the disc is compatible with the DVD player.
No sound or distorted sound –Adjust the volume.
–Check that the speakers are connected correctly.
No audio at digital output –Check the digital connections.
–Check if the audio format of the selected audio language matches
your receiver capabilities.
No DTS audio at analog output –Use a DIGITAL AUDIO OUT jack when outputting the DTS audio.
No sound and picture –Check that the SCART cable is connected to the correct device
(See Connecting to a TV)
Picture freezes momentarily –Check the disc for fingerprints/scratches and
during playback clean with a soft cloth wiping from centre to edge.
Disc can’t be played –Ensure the disc label is facing up.
–Check if the disc is defective by trying another disc.
The device cannot playback a Video CD or S-Video CD.
No return to start-up screen when –Reset the player by switching the player off, then on
disc is removed again.
The player does not respond to –Aim the remote control directly at the sensor on
the remote control the front of the player.
–Reduce the distance to the player.
–Replace the batteries in the remote control.
–Re-insert the batteries with their polarities (+/– signs) as indicated.
If no solution, please contact an authorized service centre.
Buttons do not work or player stops –To completely reset the player, unplug the AC
responding cord from the AC outlet for 5-10 seconds.
Then plug in the AC cord again.
Player does not respond to some –Operations may not be permitted by the disc.
operating commands during playback. Refer to the instructions of the disc.
DVD player cannot read –Use a commonly available cleaning CD/DVD to
CDs/DVDs clean the lens before sending the DVD player for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
Downloaded from www.Manualslib.com manuals search engine
Downloaded From Disc-Player.com Sharp Manuals