User Manual

7
WHAT TO DO BEFORE YOU CALL FOR SERVICE
Before you call for service, check the following point.
IT IS NORMAL for the refrigerator to produce the follow-
ing sounds.
• Loud noise produced by the compressor when operation
starts --- Sound becomes quieter after a while.
• Loud noise produced once a day by the compressor --
- Operating sound produced immediately after automatic
defrost operation.
• Sound of flowing fluid (gurgling sound, fizzing sound) ---
Sound of refrigerant flowing in pipes (sound may become
louder from time to time).
• Cracking or crunching sound --- Sound produced by ex-
pansion and contraction of inner walls and internal parts
during cooling.
• Squeaking sound --- Sound produced by expansion and
contraction of internal parts.
IT IS NORMAL that the outside of a cabinet may be hot
when touched. The hot pipe is in the cabinet in order to
prevent dew generation.
IF YOU STILL REQUIRE SERVICE
Refer to your nearest service agent.
CARE AND CLEANING
Some household cleaning chemicals may affect the
inside surfaces and plastic shelves resulting in split-
ting or cracks occurring.
Evaporating pan & cover;
How to remove
1.Hold both sides of Evapo-
rating pan cover and an-
gling upward.
2.Pull Evaporating pan out.
How to set
1.Put Evaporating pan on
Radiator plate, then slide
it in completely.
2.Fit the pawls of Evaporat-
ing pan cover into the
holes of the cabinet, then
push the cover to attach.
NOTE:
• Do not use polishing powder, benzine, hot water etc.
• If undiluted detergent is used or soapy water is not wiped
off thoroughly, cracking of plastic parts can result.
• Wipe any food oils adhered to plastic components as they
can cause cracking of the plastic surface.
• The glass shelves weighs approximately 3kg each. Hold
firmly when removing from the cabinet or carrying.
If you switch your refrigerator off when you are going away
for an extended period, remove all food, clean the interior
thoroughly. Remove the power cord plug from the power
socket and leave all doors open.
1.Remove the shelves and pockets from the cabinet and
door. Wash them in warm soapy dishwashing water; rinse
in clean water and dry.
2.Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off soapy
water.
3.Wipe the exterior with a soft cloth each time it is soiled.
4.Clean Magnetic door seal with a toothbrush and warm
soapy dishwashing water.
5.Evaporating pan should be removed and cleaned once
a year.
When cleaning all plastic parts inside this refrigera-
tor, only use diluted dishwashing liquid(soapy wa-
ter). Make sure that all plastic parts are thoroughly
rinsed with water after cleaning.
Switching off your refrigerator
Evaporating pan
Evaporating pan cover
Pawl
Hole
Replacing method of the lamp bulb
1.Unplug the refrigerator first to prevent electric shock.
2.Remove the light cover.
3.Replace the lamp bulb with same type.
Light
cover
Freezer : Base E12, MAX 10W, T-20
Refrigerator : Base E12, MAX 15W, T-20
Light
cover
<Refrigerator>
<Freezer>