Operation Manual

21
3
Prior to Making Entries
Preparations for Entries
■
Receipt paper roll
If the receipt paper roll is not set in the machine or it is getting low, install a new one according to section
“Replacing the Paper Rolls” under “Operator Maintenance.”
■
Receipt ON/OFF function
You can disable receipt printing in the REG mode to save paper using the receipt function.
Press the
F
key. Select “1 RCP SW.” and press the
E
key. Select “OFF” to disable receipt printing and
press the
E
key. When the function is in the OFF status, the receipt off indicator “R” is highlighted.
NOTE
Your register will print reports regardless of the receipt state. This means that the receipt roll must
be installed even when the receipt state is “OFF”.
■
Clerk assignment
Prior to any item entries, a clerk must enter his/her clerk code into the register.
To sign on:
Clerk code Secret code
(In case secret code is 0000)
LE
To sign off:
L
NOTE
Your register can provide the clerk + cashier system instead of current system (clerk only
system). If you want to change the system, please consult your authorized SHARP dealer.
Cashier assignment (Clerk + cashier system)
To sign on:
Cashier code Secret code
(In case secret code is 0000)
E
To sign off:
CSR
#
NOTE
Your register allows to connect a contactless clerk key system. If you want to use this system,
please contact your authorized SHARP dealer.