Operation Manual

216
Replacing the Paper Rolls
■
Recording paper specifi cations
Be sure to use paper rolls specifi ed by SHARP.
The use of any other paper rolls than specifi ed could cause paper jamming, resulting in register malfunction.
Paper specifi cation
Paper width: 57.5 ± 0.5 mm
Max. outside diameter: 80 mm
Quality:
High quality (0.06 to 0.08 mm thickness)
• Be sure to set a paper roll prior to using your machine, otherwise it may cause a malfunction.
• Be careful then to set the roll correctly.
(How to set the paper roll)
To the printer
Incorrect
To the printer
Correct
■
Removing the paper rolls
When a red dye appears on the paper roll, it is time to replace the existing paper roll. Replace the paper roll
with a new one. If you plan not to use your register for an extended period of time, remove the paper roll,
and store it in the appropriate place.
Print roller arm
Print roller
release lever
1.
Remove the printer cover.
<Receipt side>
2.
Lift up the print roller release lever to open the print roller arm of
the receipt side.
Open the print roller arm of the receipt side.
3.
Remove the paper roll from the paper roll cradle of the receipt side.
Cut
Take-up
spool
<Journal side>
4.
Press the
}
key to advance the journal paper until its printed part
is out of the way.
5.
Cut the paper and remove the take-up spool from the bearing.
Print roller arm
6.
Lift up the print roller arm of the journal side.
7.
Remove the paper roll from the paper roll cradle of the journal side.
8.
Remove the paper holding plate of the take-up spool, and remove
the printed journal roll from the spool.