Operation Manual

217

■

Installing the paper rolls

Remove the printer cover and open the print roller arm of the receipt

side by following the steps in “Removing the paper rolls”.

Set a paper roll in the paper roll cradle of the receipt side as per the

diagram.

Feed the end of the paper along with the paper positioning guides

as per the diagram.

While holding down the paper, slowly close the print roller arm of the

receipt side, and push down the

mark on the arm until you

hear a click locking the arm.

NOTE

If the print roller arm is not securely locked, printing is

not done right. If this problem occurs, open the arm,

and close the arm as instructed above.

Wait until the excess paper is automatically cut off, and remove it.

NOTE

Do not remove the excess paper until the receipt

cutter stops completely. Trying to remove the paper

before the cutter stops completely could cause paper

jamming.

Lift up the print roller arm of the journal side.

Set a paper roll in the paper roll cradle of the journal side as per the

diagram.

Paper positioning guides

While holding down the paper, slowly close the print roller arm of the

journal side, and push down the arm until you hear a click locking

the arm.

Spool

Paper holding plate

Remove the paper holding plate from the spool.

Insert the end of the paper into the slit in the spool. (Press the

}

key to feed more paper if required.)

Wind the paper two or three turns around the spool shaft.