Service manual

HT-X1

7 – 3

• The CD disc is not recognised. (When the laser beam does not go on)

Is the voltage of 3.4 V being applied to the emitter of Q10 ? No Check the A_5 V line.

Yes

Is the voltage of 2.3 V being applied to the pin 19 of JB1 ? No Check the line between Q15 and CP1.

Yes

Check connection of optical pickup cable.

If it is normal, replace the optical pickup mechanism unit.

Place the disc on the tray and close it.

Yes

When checked, disc starts rotating?

Yes

Refer to "Disc does not turn."

Is the level of RF signal which is output from

pin 57 of U7, normally ?

Yes

Check for contamination of objective lens of optical pickup.

Replace the DVD servo PWB unit.

Replace the optical pickup mechanism unit.

check the DVD servo PWB unit.

Yes

Both picture and sound do not operate normally. (1)