Owner`s manual

107
• Pressing and releasing the A button momentarily (< 2 sec)
will accept the ON/OFF setting, and if OFF is selected
operation will revert to the Free Surface Main screen, or if
ON is selected the Depth digits will flash allowing them to
be set (Fig. 102).
• Depressing and holding the S button will scroll upward
through the Depth Set Points from 30 to 330 FT (10 to 100
M) in increments of 10 FT (1 M) at a rate of 8 Set Points
per second until it is released.
• Pressing and releasing the S button momentarily and
repeatedly (< 2 sec each time) will step upward through the
Set Points one at a time.
• Pressing and releasing the A button momentarily (< 2 sec)
will accept the setting, and access Set DA2 (or DA3); or
after setting DA3, operation will revert to the Free Surface
Main screen.
• Depressing the M button for 2 seconds, or if no button is
pressed during a period of 2 minutes, operation will revert
to the Free Surface Main screen.
Fig. 102 - SET DA1 VALUE